Installation Instructions
FPD
3
INSPECT THE UNIT BEFORE INSTALLING
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
1.
Carefully inspect the FPD for shipping damage. If any damage
is apparent, call your carrier claims agent and do not continue
with the installation until the carrier has reviewed the damage.
NOTE: Read all instructions before starting installation.
2.
Lay out components to ensure you have all the required parts
before proceeding (see FPD drawing on page 2).
FPD INSTALLATION
WARNING: It is the responsibility of the installer to verify that
the structure to which the FPD is anchored will
safety support five times the combined load of all
attached components and equipment.
Install the FPD as follows:
1.
Determine the exact mounting location prior to installation,
considering the unit’s swing radius.
WARNING: Improper installation can result in serious per-
sonal injury! Make sure that the structural mem-
bers can support a redundant weight factor five
times the total weight of the equipment: if not,
reinforce the structure before installing the FPD.
2.
Using three 1/4-20 button head screws and bracket clamp,
secure the bracket to the pole.
3.
Make sure no power is supplied to the display before attempt-
ing to mount the display.
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
VESA Compliant Flush Mounting
CAUTION: If monitor uses a screw size other than M4, DO NOT
use the M4 screws provided. Using the wrong screws
could result in damage to your display.
A.
Start two M4 X .7 X 12mm Phillips pan head screws in the
top mounting holes of your display.
B.
Matching the hole pattern on your display with the hole
pattern on the mount, hang the mount from the two screws
started in Step A.
C.
Install two remaining Phillips pan head screws through the
mount and into the mounting holes of your display.
D.
Secure your display to the mount by tightening the four
Phillips pan head screws.
Figure 1. Secure Bracket To Pole
