FMSCAO
Installation Instructions
6
INSTALLATION
IMPORTANT ! :
Be sure to also reference ceiling system
attachment guidelines in the
Fusion Modular Systems
installation instructions.
NOTE:
The following procedure assumes that Chief ceiling
plates (not included) and extension columns (not
included) have been properly installed following
instructions provided with ceiling plates and extension
columns.
•
The ceiling plates and columns should be installed
approximately spaced at center of outside
screens.
IMPORTANT ! :
The weight of the system should be
evenly distributed across ceiling plates.
Installing Array Offset
1.
Measure depth of screens to be installed and compare to
offset position information. (Table 1)
Table 1: Offset Position for Screen Depth
NOTE:
The array offset (A) ships in the centered position. If the
screen depth is 2.5" to 4.5" leave the array offset as is,
and proceed to
Attaching Array Offset to Installed
Column
section.
2.
Loosen and remove fastener and washer from center hole
on each side of array offset (A). (See Figure 1)
3.
Loosen two outside fasteners on each side of array offset (A).
4.
Slide offset to appropriate position. (See Figure 1)
5.
Tighten two outside fasteners on each side of offset.
6.
Install and tighten fastener with washer (removed in Step 2)
into appropriate hole on each side of offset. (See Figure 1)
Figure 1
ARRAY
OFFSET
Forward
Position
Center
Position
Rear
Position
Screen
Depth
< 2.5" depth
2.5" to 4.5"
depth
> 4.5" depth
6
2
(A)
4
4
Towards front
of menu board
5
3
Forward
Rear position
Centered
position
position
center hole