Installation Instructions
FCAC SERIES
9
Figure 5
3.
Proceed to "Fabric Cover Installation" Section.
FCAC2X1M/FCAC2X1L
1.
Slide together two outside frames (C), four center joiner
tubes (F) and one center frame (B). (See Figure 6)
Figure 6
NOTE:
If there are any possible obstructions on back of display
that could interfere with uprights (D and E) installation,
measure where they will occur so uprights can be
attached accordingly. Uprights (without flags) (D) may
be installed in either Step 2, Step 4 or into any available
holes on center joiner tubes (F) depending on
obstructions or user preference.
2.
Use four #12-24 x 3/8" Phillips tapping screws (G) to secure
two uprights (without flags) (D) to outside frames (C). (See
Figure 7)
NOTE:
Example shown (See Figure 7) is to assemble a
maximum length frame. Frame can be made shorter
and must be shorter for FCAC2X1M.
3.
Use two #12-24 x 3/8" Phillips tapping screws (G) to secure
upright (with flag) (E) to center frame (B). (See Figure 7)
Figure 7
4.
Use four #12-24 x 3/8" Phillips tapping screws (G) to secure
four center joiner tubes (F) to center frame (B). (See Figure
8)
Figure 8
5.
Proceed to "Cover Installation" Section.
2
(E)
(D)
(C) x 2
(N) x 4
(P) x 4
(carts/stands installation)
(C) x 2
(F) x 2
(B)
1
1
1
1
1
1
1
1
2
(G) x 4
3
(G) x 2
(D)
(E)
(D)
(FCAC2X1L shown)
4
(G) x 4
(B)
(F) x 4
