FCA611
Installation Instructions
6
Assembly And Installation
NOTE:
The following procedure assumes the Fusion™ Cart/
Stand has already been completely assembled with the
display attached.
IMPORTANT ! :
The FCA611 shelf has been designed
specifically for Chief’s Fusion™ Series Carts and Stands.
DO NOT attempt to install this shelf onto any other cart or
stand!
1.
Remove back cover from cart/stand. (See Figure 1)
2.
Remove column inner cover from cart/stand. (See Figure 1)
3.
Remove side covers from cart/stand by sliding them up the
channel. (See Figure 1)
Figure 1
4.
Partially install 1/4-20 x 3/8" set screw (H) into accessory
bracket (B). (See Figure 2)
5.
Slide accessory bracket (B) with set screw (H) into side
channel. (See Figure 2)
Figure 2
6.
Slide accessory bracket B) up or down in side channel until
desired mounting height is reached. (See Figure 3)
7.
Tighten set screw (H) to lock bracket in position. (See
Figure 3)
8.
Repeat Steps 4-7 on other side, making sure bracket
position lines up horizontally with the other bracket.
9.
Use four 1/4-20 x 3/8" button head cap screws (G) to secure
right and left shelf supports (D and E) to accessory brackets
(B). (See Figure 3)
10. Use four #10-24 x 3/8" button head cap screws (F) to secure
right and left shelf supports (D and E) to center support
bracket (C). (See Figure 3)
Figure 3
(display not shown for clarity)
2
2
3
1
1
side covers
column inner
cover
back cover
(display not shown for clarity)
(B)
(H)
4
5
6
(G) x 4
7
9
(D)
(E)
(F) x 4
10
(C)
