Installation Instructions
JHS SERIES
5
Figure 3
2.
Align two screws in display back with upper mounting holes
in Centris cup and lower display until screws are seated in
lower area of teardrop mounting holes. (See Figure 4)
3.
Install two more of the same screws through lower mounting
holes in Centris cup and into display back. (See Figure 4)
4.
Tighten all hardware.
5.
Route cables and wires to display.
Figure 4
Adjustments
To adjust display Roll, Pitch, and YAW tension:
1.
Disconnect all wires and cable from the display.
2.
Remove two
Lower
screws securing display to Centris cup.
3.
Loosen two
Upper
screws securing display.
4.
Lift display upward and away from mount.
5.
Using a hex head wrench turn the tension adjustment screw
clockwise to increase tension, or counter-clockwise to
decrease tension. (See Figure 5)
6.
Re-install display.
Figure 5
x2
1
x 2
2
3
4
