Status light indicator
¾
Battery Status Led
Battery low : Red LED will be lighted for 0.5seconds and will be lighted again after 5 seconds. This will be
repeating until no power or start recharging.
¾
Connect Status Led
Power ON : Blue LED brighten 5sec
Pairing
:
Blue LED flash 0.5s/0.5s (3min)
Searching: Blue LED brighten 5sec continued to success
Charging: Red LED flash 0.5s/0.5s
Charging full: Red LED turn off
Before Use
¾
Recharging the battery
Plug USB recharge cable from keyboard to PC USB hub or USB adaptor at least 10 minutes. Ensure battery power is
above low level.
¾
Set power switch is On
Configuring the Keyboard
Configuring Steps
Operation of the Bluetooth software may vary depending on your personal computer/device. For details, refer to the manuals
provided with your personal computer. The setup instructions are based on your operating system.
Case A: Click (Start), then “Control Panel.”
Case B: Click the “Hardware and Sound” icon.
Case C: If the “Bluetooth Devices” icon is in the “Hardware and Sound” window: Then go to following D, if the
“Bluetooth Devices” icon is not visible in the “Hardware and Sound” window: Close the “Control Panel” and go to
pre-install XP section.
Case D: Click the “Bluetooth Devices” icon, and verify the contents of the window displayed. If you switch to Classic
View, double-click the “Bluetooth Devices” icon.
Case E: Review the Bluetooth Devices windows shown here. If you see window 1, go to the instructions in
Step (A)
. If
you see window 2, go to the instructions in
Step (B)
.
Window 1
Window 2