Chicco Cuddle & Bubble Comfort, Manual, Page: 10 / 52

10 11
CUDDLE & BUBBLE
IMPORTANT. RETAIN FOR FU-
TURE REFERENCE. READ CARE-
FULLY.
WARNING: BEFORE USE, RE-
MOVE AND DISPOSE OF ALL
PLASTIC BAGS AND PACKAG-
ING MATERIALS AND KEEP
THEM OUT OF REACH OF CHIL-
DREN.
INTRODUCTION
CUDDLE & BUBBLE Comfort is a practical and
functional changing table with baby bath, de-
signed to nestle the baby during diaper chang-
ing and bath time.
Components
A - Frame
A1 - shelf with handle
A2 - changing table
A3 - feet (2x)
A4 - feet with wheels (2x)
A5 - intersections with buttons (2x)
A6 - securing blocks (2x)
A7 - securing straps (2x)
A8 - safety strap
B - Tub
B1 - rubber plug
B2 - drain cap and hose
C - Accessories
C1 - storage basket
C2 - head wash
C3 - sponge basket with lid
C4 - fabric reducer
WARNINGS FOR THE CHANGING TABLE
• The changing table can be used for infants
from moment of birth up to 12 months and 11
kg. For home use only.
•
WARNING:
Do not leave the child unattended.
•
WARNING:
Take into account risk of free
flames and other sources of strong heat such
as electric stoves, gas stoves, etc. in the imme-
diate vicinity of the product.
•
WARNING:
Make sure that the wheel brakes
are engaged before use.
• Never use the product without tub mounted
on the frame.
• The changing table mat must always be fixed
onto the frame when used. The changing table
must always be used with padding on the lid
so as to provide sufficient barrier to protect the
baby against falls.
• Do not use the product if any part is broken,
torn or missing.
• Do not use accessories, spare parts, or any com-
ponent not supplied or approved by the man-
ufacturer.
• This product must only be used by an adult.
• To avoid the risk of injury, make sure that the
space above the product is suitable (there
should be no shelves, furniture, etc..).
• Do not place more than one child at a time in
the changing table.
• Do not place the product on surfaces that are
not perfectly flat.
• All securing devices for assembly must be
tightened correctly and checked regularly.
• Do not allow other children to play unsuper-
vised near the product.
• Wait for the product to cool before placing the
baby onto it whenever it has be exposed to
heat.
• Do not overload the bottom shelf with weights
exceeding 7 kg.
• When unused, the product should be kept out
of reach of children.
USING THE CHANGING TABLE
Assembly
• The boxed product is already partially assem-
bled and the following instructions must be
performed to complete it:
1. Place frame A still packaged onto the floor
horizontally (fig. 1).
2. Install the 4 feet A3 and A4 (fig. 2).
All feet can be adjusted at 3 heights.
WARNING: To ensure the stability of the product,
make sure all the feet are mounted at the same
height, checking for proper engagement of the
pins into the holes on the legs (fig. 3).
WARNING: the two feet with the wheels A4 must
be installed on the same side of the product.
3. At this point, position the frame A upright,
grasp the two upper tubes and push them in
the opposite direction to open the product
(Fig. 4).
4. Pry down on both the intersections A5 until
you hear the engagement click (fig. 5).
5. Push the shelf A1 downwards by placing your
hand over the centre handle until fully engag-
ing it on the frame cross tube (fig. 6).
6. Install the storage basket C1 at the centre of
EN