Page 2
SKU 3223
For technical questions, please call 1-800-444-3353.
Specifications
Welding Process
Resistance Weld
Power Requirement
120 V~, 60 Hz, ~40 A Peak
Recommended
Circuit
20 A (dedicated)
Switch
Pushbutton, momentary
Circuit Breaker
Pushbutton reset; Rating: 125/250 VAC, 60 Hz, 10 amp
Stud Weld Time
0.5 to 1.0 seconds
Line Cord
6 foot, 3-prong plug, UL listed
Weight
10.1 lb.
Accessories
- Bag: 100 each 2mm, 3mm, 4mm studs; steel with copper coating
- 2 lb. slide hammer dent puller
- One of each nozzle (2mm, 3mm, 4mm)
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
Keep work area clean
1.
. Cluttered areas invite injuries.
Observe work area conditions
2.
. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
Keep children away
3.
. Children must never be allowed in the work area. Do not let them
handle machines, tools, or extension cords.
Store idle equipment
4.
. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
Use the right tool for the job
5.
. Do not attempt to force a small tool or attachment to
do the work of a larger industrial tool. There are certain applications for which this
tool was designed. It will do the job better and more safely at the rate for which it was
intended. Do not modify this tool and do not use this tool for a purpose for which it was
not intended.
Dress properly
6.
. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically non-conductive clothes and non-skid footwear are
recommended when working. Wear restrictive hair covering to contain long hair.
Do not overreach
7.
. Keep proper footing and balance at all times. Do not reach over or
across running machines.
REV 04b, 04e, 07e
