Chicago Pneumatic CP 0044, Safety And Operating Instructions Manual

Page: 21 / 108

Troubleshooting
If the machine does not start, has low power or
uneven performance, check the following points.
♦
Check that the cutting blade being used has the
correct dimension.
♦
Check that the machine is getting the correct
amount of lubricant. Too much lubrication can
cause starting problems, low power or uneven
performance.
♦
Check that the compressed air system supplies
the machine with sufficient air pressure to give
full power.
♦ Check that the dimension and length of the air
hose are according to the recommendations. See
“Installation”.
♦
If there is a risk of freezing, check that the
machine's exhaust ports are not blocked.
♦
If the machine is still not satisfactory after this
procedure, contact an authorised service
workshop.
Storage
> Clean the machine properly before storage, in
order to avoid hazardous substances. See “Dust
and fume hazard”
> Pour approximately 1 ⁄
2
oz (5 cl) of oil directly into
the air inlet nipple, connect the machine to the
compressed air supply and start it for a few
seconds.
> Always remove the blade after use and store it
carefully on a firm level surface.
> Avoid moisture and temperature extremes.
> Always store the machine in a dry place.
Disposal
A used machine must be treated and disposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in respect to local restrictions.
21 9800 0543 90b | Original instructions
Safety and operating instructions CP 0044