Copyright © Chicago Gaming Company
Page 4
HIGH VOLTAGE PRESENT.
SHOULD BE PERFORMED BY
TRAINED TEHCNICIAN
Setting Coin Comparator
Bikini Bottom Bowling ships with a faux plastic token installed in the coin
comparing mechanism. Follow the instructions below to set up the machine
to accept the preferred coin or token.
1) Using the key, open the control panel.
2) Locate the coin comparator mechanism on the right side. (See image
below)
3) Making sure not to drop the token, lift up the coin retainer holding the
token in place.
4) Remove the token and set to the side.
5) Lift the coin retainer and place the new coin or token in the slot (It may be
easier to place the coin in the underside of the top of the retainer, then
lower it into place.)
6) After making sure the coin is in place, close the control panel.
7) The coin comparator automatically adjusts when a new coin or token is
inserted.
Reinstalling Software
1) With the power on, open the control panel
2) Being careful not to disconnect any wires, reach down to the computer
and open the disc drive.
3) Place the Restore DVD in the tray and close the disc door.
4) Using the switch on the back of the game, turn the power off for 30
seconds.
5) Turn the power back on.
6) The small green light near the disc tray will blink erratically, and then turn
off for 35-40 seconds.
7) The disc read light will rhythmically flash for 20-25 minutes. DO NOT
TURN THE UNIT OFF DURING THIS TIME.
8) After this time, the light will stop flashing.
Pull Up on The
Coin Retainer to
Exchange Coins