Page 12
Item 97360
For technical questions, please call 1-888-866-5797.
Positioning the Tile
1.
FIGURE 10
POSITION OF TILE
BUTTERFLY KNOB (47)
TABLE (44)
ANGLE CUTTING
GUIDE (46)
SCALE
RAIL
(49)
Loosen the T-Knob (47) on the Angle Cutting
Guide (46) and position at 90 degrees on the
Scale Rail (49). Then, retighten the T-Knob.
(See Figure 10.)
2.
To Adjust the gap between the Angle Cutting
Guide (46) and the cutting slot in the Table
(44), loosen the Butterfly Knob (47) on the
Scale Rail (49). Move the Scale Rail to
the desired position. Then, retighten the
Butterfly Knob on the Scale Rail.
(See Figure 10.)
3.
Position the tile against the Scale Rail (49)
and Angle Cutting Guide (46).
(See Figure 10.)
4.
Check to make sure the water level in
the Water Tray (67) is at the proper level
(the Water Pump (7) should be about
3/4 submerged). Then slide in the Water
Tray completely. (See Figure 9.)
5.
Plug the Power Cable (20) into the
nearest 120 volt, grounded, electrical
outlet, making sure to form a “drip loop”
with the Power Cord. (See page 10.)
6.
FIGURE 11
CIRCUIT BREAKER (32)
POWER
SWITCH
(37)
Turn the Power Switch (37) to its “ON”
position, and allow the Saw Blade (4) to
spin up to full speed. (See Figure 11.)
7.
HANDLE (38)
SAW
BLADE
(4)
TILE
FIGURE 12
Hold the tile firmly against the Angle Cutting
Guide and Scale Rail (49) with one hand.
Always keep fingers a safe distance away
from the Blade (4). With the other hand, hold
the Handle (38) and slowly move the Saw
Blade forward over the tile. (See Figure 12.)
8.
Continue moving the Saw Blade (4) over the
tile until the cut is completed.
(See Figure 12.)
9.
Once the cut is completed, turn the Power
Switch (37) to its “OFF” position and allow
the Saw Blade to stop on its own. Unplug
the Power Cord from its electrical outlet.
Then, remove the cut tile and debris from the
Table (44). (See Figure 11 and Figure 12.)
10. NOTE: If the Motor of the Tile Saw stops
suddenly while cutting, turn the Power
Switch (37) to its “OFF” position. Wait
approximately 5 minutes. While making
sure your hands are dry, reset the Circuit
