Page 6
SKU 96635
For technical questions, please call 1-800-444-3353.
speciFications
Operating Drill Speed
Minimum 1,000 RPM
Maximum 2,300 RPM
Drill Chuck Size
3/8” or 1/2”
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
opeRating instRuctions
Read the entiRe impoRtant
saFetY inFoRmation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
tool set up
to pReVent
seRious injuRY
FRom accidental
opeRation:
turn the power switch of the
drill to its “oFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
work piece and work area set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Secure loose workpieces using a vise
2.
or clamps (not included) to prevent
movement while working.
There must not be hazardous
3.
objects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
general operating instructions
Choose the best blade for the
1.
intended use:
The long blade should be used for
•
pruning.
The coarse toothed blade should be
•
used to cut wood and plaster.
The fine toothed blade should be
•
used to cut metal and plastics.
Rotate the Drive Shaft manually
2.
until Blade Holder (2) clears the
attachment. Loosen both Hex
Screws (3 & 5) and insert the Blade
(18) into the Blade Holder (2).
Tighten Hex Screws, making sure
3.
that the tab on the Spring Plate
threads through the eyelet on the
Blade.
Insert the Drive Shaft (13) of the
4.
Attachment into the chuck of the drill
and tighten it securely.
Plug the power cord of the drill into
5.
an appropriate power outlet.
Hold the attachment firmly in one
6.
hand and the drill in the other hand.
Squeeze the trigger of the drill and
7.
allow the Saw Attachment to build up
to full speed before starting the cut.
Lean the blade slowly into the work
8.
piece. Do not push hard on the tool,
waRning
