SKU 95848
for technical questions, please call 1-800-444-3353.
PAGE 12
Drill only as deep as necessary. Do not drill deeper than necessary into walls or other
areas where you cannot identify any possible hazards behind the drilling surface.
To reduce jamming as the Bit breaks through the workpiece, decrease the drilling
pressure when the point of the Bit breaks through the workpiece.
When you have drilled the hole, remove the Bit from the hole while the Cordless
Drill is still running. This prevents the Bit from getting caught in the hole and caus-
ing damage.
When driving screws, start with a low torque setting.
If the clutch starts slipping before the screw is in all the way, stop the drill, put the
Rotation Button (9) in the center position and change the torque setting. Reset the
rotation direction before continuing.
Release the Trigger (10) to stop the Drill. Then, remove the Battery Pack, put the
Rotation Button in the center position, and remove the bit from the Drill.
INSPECTION, MAINTENANCE, AND CLEANING
WARNING!
Remove the battery Pack (28) from the tool and set the Rota-
tion button (9) to its center, locked position before performing any inspection,
maintenance, or cleaning.
bEfORE EACH USE,
inspect the general condition of the Cordless Drill. Check for
misalignment or binding of moving parts, cracked or broken parts, leaking Battery
Pack, damaged Charger wiring, chipped or broken Drill Bits, and any other condi-
tion that may affect its safe operation. If abnormal noise or vibration occurs, have
the problem corrected before further use.
Do not use damaged equipment.
DAILy:
With a soft brush or cloth, remove all dirt and debris from the Cordless Drill.
Do not immerse the Cordless Drill in any liquids.
When the battery needs replacement keep in mind that the Nickel-Cadmium
(Ni-Cd) battery in this tool must be recycled or disposed of properly.
14.
15.
16.
17.
1.
2.
3.
4.
