SKU 95380
For technical questions, please call 1-800-444-3353
PAGE 13
BASIC OPERATING INSTRUCTIONS
WARNING! Use safety equipment. Always wear ANSI-
approved safety impact eye goggles.
Dust mask or respirator,
and hearing protection must be used for appropriate conditions.
1.
Make sure the Power Switch of the Router Table is in its “OFF” position
and the Table is not plugged into an electrical outlet.
Then, install a
Router Bit (not included) onto the Router and adjust its cutting depth.
2.
Make all necessary adjustments to the Router Table’s Fence (6B),
Adjustable Fence (9B), and Miter Gauge (12B) depending on the
cut(s) to be made to the workpiece. Also, check to make sure
the retractable Guard (8B) is in proper working order.
3.
Check to make sure the Router Table’s Power Switch/Outlets (2B) assembly
is in its
“OFF”
position. Then connect the Router Table’s Power Switch/
Outlets assembly into the nearest 110 volt, grounded, electrical outlet.
4.
Note:
Before first use of the Router on a workpiece it is recommended
that you test and practice with the Router using a scrap workpiece.
5.
Insert the Safety Key of the Router Table’s Power Switch/Outlets (2B), and pull
up on the Power Switch to provide power to the Router Table and Router.
6.
Make sure to hold the workpiece firmly against the Router Table’s
Stationary Fence (6B), Adjustable Fence (9B), and Miter Gauge
(12B) depending on the cut(s) to be made to the workpiece.
7.
Allow the Bit of the Router to rotate up to full speed,
then feed the workpiece
gradually from right to left against the rotation of the Bit.
Keep the feed
rate constant. Feeding the workpiece too quickly will slow the motor of the
Router. Feeding the workpiece too slowly will cause burns to the workpiece.
8.
On very hard wood or large cuts it may be necessary to make more than one
pass at progressive depth settings until the desired depth of cut is made.
9.
When finished, remove the workpiece from the Router Table. Turn the Power
Switch/Outlets (2B) assembly to its
“OFF”
position and remove the Safety Key.
Then, disconnect the Power Switch/Outlets assembly from its electrical outlet.
10.
Allow sufficient time for the Router Bit to stop rotating and also to
completely cool before removing the Bit from the Router.
11.
Always store the Router and Router Table in a clean, dry, safe
location out of reach of children and other unauthorized people.
