SKU 91935
For technical questions, please call 1-800-444-3353
Page 11
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE:
For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 24 and 25.
To Replace And Install A Saw Blade:
1.
WARNING! Prior to performing any assembly and/or adjustment
procedures, make sure the Power Cord (116) of the Miter Saw is unplugged
from its electrical outlet. Make sure the unit has completely cooled, and
wear heavy duty work gloves.
2.
When replacing the Saw Blade (95), make sure the new Saw Blade has a
diameter of 8-1/4”,
an
RPM rating of at least 4600,
and an
arbor hole of 5/8”
diameter.
3.
When installing a Saw Blade (95), make sure the teeth of the Saw Blade point
downward, and that the direction of the arrow shown on the Saw Blade matches
the direction of the
arrow shown on the Blade Case (86).
(See Figure E, next page.)
4.
Lock the Saw Blade (95) in its
upward position. To do so, pull out on the Lock
Pin Knob (35). Raise and hold the Blade Case (86) of the Miter Saw fully upward.
Turn the Lock Pin Knob 90 degrees. Then, insert the Lock Pin (38) into the
deep
slot in its locked position.
(See Figure F, next page.)
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts List on pages 22
and 23
are included. If any parts are missing or broken, please call Harbor Freight Tools
at the number shown on the cover of this manual as soon as possible.
SYMBOLOGY
FIGURE D
