Page 10
For technical questions, please call 1-800-444-3353.
Item 69946
SAFET
y
O
PERA
TION
M
AINTENANCE
SETUP
Installing the Battery Pack
1. Place the battery pack in the tool,
aligning the arrows on the battery
pack with the arrows on the tool.
2. Press the battery pack into the tool.
Make sure that the battery pack snaps
into place, and that the battery pack is
secure in the tool before beginning use.
Removing the Battery Pack
1. Press the Release Tabs (19) on
both sides of the battery pack to
release the battery from the tool.
2. Remove the battery pack from the
tool by pulling straight out.
Inserting a Bit in the Tool
TO PREVENT SERIOUS INJURy FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off, wait for the motor to stop, and remove
the battery pack before adjusting tool or installing accessories.
TO PREVENT SERIOUS INJURy FROM ACCESSORy FAILURE:
Only use accessories that are rated at or above the RPM rating of the Cordless Rotary Tool.
1. Depress the Spindle Lock (10).
Rotate collet until shaft is engaged by the lock.
2. Loosen the Collet Nut (1) by turning it
counterclockwise, using the Wrench provided.
WARNING!
If you are changing a bit immediately
after use, be careful not to touch the bit. It may
be very hot from use, possibly causing injury.
Allow the bit time to cool before handling it.
3.
To remove a bit:
Pull the bit straight out
of the Collet once the Collet Nut is loose.
To insert a bit:
Insert the shank end if the bit
into the Collet once the Collet Nut is loose.
Collet Nut
Collets
NOTE:
Your tool is provided with two collets,
1/8″ and 3/32″ diameter. These are precision
manufactured to fit comparably sized bits.
Do not force a bit into the wrong sized collet, and
do not modify a mismatched collet or bit.
Severe personal or property damage may
result from using mismatched collets or bits.
4. Tighten Collet Nut securely using the
provided wrench. Ensure that the spindle
lock is released before turning on the tool.
Summary of Contents for 69946
Page 1: ......
