Page 12
For technical questions, please call 1-888-866-5797.
Item 68988
Sa
FE
ty
Op
ER
at
IO
n
Ma
Int
Enanc
E
SE
tup
adjusting Depth
1. Set the Base flat against the
edge of the workpiece.
2. Loosen the Depth Lock Lever to allow
the depth of cut to be adjusted.
3. Use the Depth Scale located behind the
housing to set depth of cut.
WaRnInG! to reduce the risk of
serious injury, adjust the depth
of cut to just barely clear the
workpiece and remove shavings.
4. After adjustment, tighten the
Depth Lock Lever.
WaRnInG! tighten Depth
lock lever before use.
Depth
lock
lever
Depth
Scale
Figure D
adjusting Bevel
1. Loosen the Bevel Lock Lever to allow
the angle of cut to be adjusted.
2. Use the Bevel Scale to set the desired angle.
3. After adjustment, tighten the
Bevel Lock Lever.
WaRnInG! tighten Bevel
lock lever before use.
Bevel
lock
lever
Bevel
Scale
Figure E
Installing and adjusting Fence
1.
to install:
Remove Fence Lock Nut,
slide ruler through slots, then replace
Fence Lock Nut.
2.
to adjust:
Loosen Fence Lock Nut and slide
the Fence to the desired width of cut.
note:
The ruler on the fence shows
the approximate width of cut.
3. If needed, remove the Fence
entirely. Otherwise, tighten the
Fence Lock Nut after adjustment.
WaRnInG! tighten Fence
lock nut before use.
Fence lock nut
(not visible)
Fence
Slot
Slot
(not visible)
Figure F
