Page 9
For technical questions, please call 1-800-444-3353.
SKU 68848
3.
Especially avoid placing the Charger
on carpets and rugs; they are
not only flammable, but they also
obstruct vents under the Charger.
4. Place the Charger on a stable, solid,
nonflammable surface (such as a stable
metal workbench or concrete floor) at
least 1 foot away from all flammable
objects, such as drapes or walls.
5. Charging room temperature: 50° - 104° F.
6. Keep a fire extinguisher and a smoke
detector in the charging area.
Battery Pack Set Up
1. Allow the battery pack to cool
completely before charging.
2. Inspect the battery pack before
charging; do not charge a cracked
or leaking battery pack.
Charging Instructions
1. Plug the charger into a grounded,
120 V~, 60 Hz outlet. Do not use an
extension cord. The Green LED will
light to show the power is connected.
Battery Pack
(sold separately)
Red
LED Green
LED
Charger
(sold separately)
Figure B: Charger Indicators
2. Slide the Battery Pack into the charger
until the button on the Battery Pack clicks
into place. The Red LED will flash to
show the Battery is charging and the
Green LED will continue to stay lit.
Note:
If the Battery does not fit properly,
disconnect it and confirm that the Battery Pack
is the correct model for this Charger as shown
on the Specification chart.
Do not charge
any other Battery Pack or any Battery Pack
that does not securely fit the Charger.
3. Frequently monitor the Charger and
battery pack while connected.
4. For a fully discharged battery or a new battery,
allow the Battery Pack to Charge for 1 hour.
The Red and Green LED’s will stay on (not
flash) when the battery is finished charging.
5. Unplug the Charger and disconnect it
from the Battery Pack when finished.
6. Allow the Battery Pack to cool
completely before using it.
7. Store the Charger and Battery Pack
indoors, out of reach of children.
Work Piece and Work
Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Secure loose work pieces using
a vise or clamps (not included) to
prevent movement while working.
3. There must not be objects, such as
utility lines, nearby that will present
a hazard while working.
General Operating Instructions
1. Plug the Power Cord into the nearest
120 volt, grounded, electrical outlet.
2. Position the saw blade of the Jigsaw about
1/2 IN. from the beginning cut line on the
workpiece. Do not allow the saw blade
to come in contact with the workpiece.
3. Squeeze the Trigger (41) to turn on the Jigsaw.
4. Allow the Saw Blade to stroke at full
speed before slowly feeding it into the
workpiece. Then, finish making the cut.
