Page 3
For technical questions, please call 1-800-444-3353.
SKU 68819
14.
MaIntaIn tooLS WIth CaRe.
Keep tools sharp
and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
15.
DISConneCt tooLS
before servicing;
when changing accessories, such as
blades, bits, cutters, and the like.
16.
ReDuCe the RISK oF unIntentIonaL
StaRtInG.
Make sure switch is in
off position before plugging in.
17.
uSe ReCoMMenDeD aCCeSSoRIeS.
Consult the owner’s manual for recommended
accessories. The use of improper accessories
may cause risk of injury to persons.
18.
neveR StanD on tooL.
Serious injury
could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
19.
CheCK DaMaGeD paRtS.
Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that
it will operate properly and perform its intended
function – check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
20.
DIReCtIon oF FeeD.
Feed work into
a blade or cutter against the direction of
rotation of the blade or cutter only.
21.
neveR Leave tooL RunnInG unattenDeD.
tuRn poWeR oFF.
Don’t leave tool
until it comes to a complete stop.
Grounding Instructions
to pRevent eLeCtRIC ShoCK anD
Death FRoM InCoRReCt GRounDInG
WIRe ConneCtIon
ReaD anD FoLLoW theSe
InStRuCtIonS:
110-120 v~ Double
Insulated tools:
tools with two prong plugs
Figure a: outlets for 2-prong plug
1. To reduce the risk of electric shock, double
insulated equipment has a polarized plug
(one blade is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
2. Double insulated tools may be used in either of the
120 volt outlets shown in the preceding illustration.
(See Figure a: outlets for 2-prong plug.)
Miter Saw Safety Warnings
For Your own Safety Read Instruction
Manual before operating Miter Saw
1. Wear eye protection.
2. Keep hands out of path of saw blade.
3. Do not operate saw without guards in place.
4. Do not perform any operation freehand.
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop before
moving workpiece or changing settings.
7. Disconnect power before changing blade or servicing.
8. Return all guards to original position if any are
moved during blade replacement. Check all
guards for proper operation after service.
9. The Lock Pin is to be used only to lock the head
in place for carrying and storage. It is not to
be used for any cutting operation.
10. The use of accessories or attachments not
recommended by the manufacturer may
result in a risk of injury to persons.
11. When servicing use only identical replacement parts.
12. Only use safety equipment that has been approved
by an appropriate standards agency. Unapproved
