Page 8
For technical questions, please call 1-800-444-3353.
SKU 68303
General Operating Instructions
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the
tool from its electrical outlet before adjusting tool or
installing accessories.
1. With the tool unplugged, mount the attachment in place.
2. Pull the Power Switch back to its off position.
Then plug the Power Cord into the nearest
120 volt, grounded electrical outlet.
3. To turn on the tool, slide the Power Switch forward.
4. Do not allow contact between the Scraper and
workpiece until the tool is running at full speed.
5. Avoid contact with foreign objects such as metal
screws and nails when sanding, scraping, or cutting.
6. Do not apply excessive pressure on the
tool. Allow the tool to do the work.
7. When finished, turn off the tool and allow it to
completely stop before setting it down. Then
unplug the tool from its electrical outlet.
8. Prior to storing the tool, remove the attachment and
wipe it clean. Store the Tool in a clean, dry, safe
location out of reach of children and other
unauthorized persons.
Maintenance and Servicing
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the
tool from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal
noise or vibration occurs, have the problem
corrected before further use.
Cleaning, Maintenance,
and Lubrication
1. BEFORE EACH USE, inspect the general condition
of the Tool. Check for loose screws, misalignment
or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that
may affect its safe operation.
The Sanding Sheets should not be dull or contain
excessive debris build-up.
The Angle Scraper and Cutting Blade
should be clean and sharp.
2. AFTER USE, clean external surfaces
of the tool with clean cloth.
3. If you notice decreased performance, have
the unit serviced and Carbon Brushes
replaced by a qualified technician.
4.
WARNING! If the Power Cord of this
Tool is damaged, it must be replaced only
by a qualified service technician
.
