Page 15
For technical questions, please call 1-800-444-3353.
SKU 67648
should rest flat against the Inner Flange.
wArning: to prevent serious
injury, gaskets must be used for all
grinding wheels they are provided
with. gaskets help prevent grinding
wheel damage and wheel slippage,
causes of wheel failure.
Thread the Outer Flange clockwise onto
6.
the Spindle. Using the Spanner (53)
tighten only enough so that the wheel is
securely held on the spindle.
wArning: to prevent serious
injury, do not overtighten flange.
Overtightening can damage the wheel,
causing wheel failure.
work piece and work Area Set up
Designate a work area that is clean and
1.
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
Secure loose work pieces using a vise
3.
or clamps (Sold separately) to prevent
movement while working.
There must not be hazardous objects,
4.
such as utility lines or foreign objects,
nearby that will present a hazard while
working.
You must use personal safety equipment
5.
including, but not limited to, ANSI-
approved eye and hearing protection, as
well as heavy work gloves.
Before beginning work, provide for
6.
sparks and debris that will fly off the work
surface.
general Operating instructions
tO preVent
SeriOuS injurY:
Grip the tool firmly in both
hands.
Press and release the Trigger to make
1.
sure the Trigger is not locked in the on
position.
Plug the Cord (52) into the electrical
2.
outlet.
Hold the Handle (43) with one hand
3.
and the Auxiliary Handle (23) with your
other hand. Always use two hands when
operating this tool.
To start the motor, press and hold the
4.
Trigger (47), then press and hold the
Lock-on Switch (46). Release the Trigger
then the Lock-on Switch. The motor will
be locked on.
Allow the tool to come up to full speed
5.
before touching the work material.
Apply the wheel to the work material at
6.
a 10° – 15° angle, allowing the tool to
operate at full speed. If the tool bogs
down, use lighter pressure.
To create a smoother surface, keep the
7.
tool moving over the work surface.
To stop the tool, press and release the
8.
Trigger.
Allow the tool to come to a complete stop
9.
before setting it down.
To prevent accidents, unplug the tool
10.
after use. Clean, then store the tool
indoors out of children’s reach.
note:
Do not cover the vents when the tool is
in use. This may cause damage to the
motor and reduce the efficiency of the
tool.
