Page 6
SKU 42934
1. Plug the Line Cord into the electrical outlet, or into an approved extension cord.
2. Grasp the Handle with one hand, and the body with the other hand.
The Angle Grinder must be used with the Guard in between you and the grinding
wheel. If may be necessary to loosen, rotate, and retighten the Guard to achieve this
position.
3. Press down on the Trigger (3).
The motor will start. Allow the motor to attain full speed before grinding.
4. For cutting or grinding, approach the material at an angle between 15 and 30 degrees
to the wheel. Maintain that angle until the cutting is complete.
Let the wheel do the work. Never apply too much pressure.
5. Optionally, to lock the Trigger in the ON position, slide the Trigger tab back.
6. When finished working, let go of the Trigger to turn it OFF.
If the Trigger was locked ON, press the Trigger in to unlock it, and the let go, turning
the unit OFF.
7. Hold the tool with both hands until the motor stops, then set it down.
Maintenance
1. Periodically blow out the motor air vents with compressed air to keep clean.
2. All plastic parts should be cleaned with a clean damp cloth.
Never use solvents.
3. Over time, if the performance of the tool diminishes, or it stops working completely, it
may be necessary to replace the motor’s Carbon Brush Assembly (8, 19, 1, and 20).
This procedure must be completed by a qualified technician.
4. When not in use, store the Angle Grinder in it’s metal box and store in a clean and dry
location (away from the hands of children).
5. Under normal operating conditions, lubrication is not required.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DIS-
TRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANU-
FACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
