Page 6
SKU 02811
Inserting Battery into Unit
Caution: Before inserting the Battery Pack into the Miter Saw, be certain that the Trigger
Switch is in the Off position. Otherwise, the Saw Blade will start turning immediately,
creating an unsafe condition.
1.
Insert Battery (40) into the receptacle at the back of the Miter Saw.
2.
Secure the Lock-spring Clasps to each side of the receptacle. See photos below.
Operation
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities, contain chemicals known [to the State of California] to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals
are:
•
Lead from lead-based paints
•
Crystalline silica from bricks and cement or other masonry products
•
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles. (California Health & Safety Code 25249.5,
et seq. )
Auxiliary Wood Fence
To help avoid small, short cut pieces of stock from being caught by the blade or shot off, it
is recommended to mount an auxiliary wood fence (not supplied) to the saw’s metal Fence
(55).
1.
Cut a 1/2 inch thick piece of wood to match the height and length of the metal Fence.
Battery (40)
Lock-spring
Clasps
Lock Button (37)
Switch Button (44)
Arm Release
Knob (17)
Table Lock
Screws (52)
Bevel Angle
Screw (1)
2811.p65
10/10/03, 9:59 AM
6