Chicago Dryer Edge MAXX, Instruction Manual

Page: 168 / 288

Repair Edge MAXX
7-36
Figure 7-48: Slowly rotate the motor and roll the
belt off its pulley.
Figure 7-47: A side conveyor motor cover is located
at each end of the machine.
To apply the tape:
Cut a 3-1/8” to 3-3/16” (80 mm) strip
for each placement.
Remove the backing from the tape
Line the tape up with the center
mark.
Wrap the tape around the roll and butt
the ends together .
Repeat Step 7 for each tracking tape loca-
tion.
Bring the ribbons back into position and
replace the connecting pins.
7.
a)
b)
c)
d)
8.
9.
Side Conveyor Drive Belt Tension
Adjustment
Over time, a side conveyor’s power twist
drive belt will stretch due to normal wear and
tear. Tension on the belt must be adjusted if it is
noticeably slack or if it begins to slip.
Required Tools
Phillips screwdriver, pliers
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Locate the motor cover for the side con-
veyor drive belt which needs adjustment
(Figure 7-47).
Remove the screws which secure the cover
and move it out of the way.
Remove the side conveyor drive belt by
slowly hand-turning the motor drive pul-
ley (Figure 7-48) and rolling the belt off.
1.
2.
3.
3.
TOC INDEX