Edge MAXX
Repair
7-23
Make sure the DISCHARGE CONVEY-
OR UP/DOWN switch is in the DOWN
position.
Turn power off at the main disconnect
switch.
Locate the spring tension adjustment bolt
at the center of the arm under the belt
(Figure 7-29). Tighten the nut to increase
the tension on the spring until the belt can
be moved by hand.
Pull the belts around until the lacing clips
are accessible.
Remove the connecting pin and attach the
new belt with the pin.
Pull the old belt through until the new belt
is in place. Never turn on the power when
pulling the belts through. This is danger-
ous and unnecessary.
Disconnect the old belt and secure the
replacement belt with a new pin.
Loosen the nut holding the tension on
the spring until the tension on the belts
is correct.
Make sure there is at least a 1/4” gap be-
tween the tensioning nuts and the fixed re-
taining plate (Figure 7-29) to allow proper
belt movement during operation.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Lower Spreader Belt Gap
Adjustment
When the flatwork is pulled to one side as
it is being spread, the gap between the belts
on the pulling side is too small and needs to be
adjusted.
When the spreading and lay down of the
flatwork is not smooth, the gap between the belts
may be too large.
Required Tools
9/16” wrench, pliers, thin slotted
screwdriver
Perform only when the unit is OFF
with power disconnected.
Make sure the DISCHARGE CONVEY-
OR UP/DOWN switch is in the DOWN
position.
Turn power OFF at the main disconnect
switch.
Turn ON the compressed air supply to
the unit.
Locate the main solenoid air valve on the
inside wall of the left endframe (Figure
7-30) and locate the valve’s override
screw.
1.
2.
3.
4.
Figure 7-30: Override screw for main air solenoid
valve located on the inside wall of the
left endframe.
TOC
INDEX
Summary of Contents for Edge MAXX
