10
9
Battery installation
SQ-816/SQ-216 transmitter requires 3 pieces of " AA " size battery to operate.
Please insert the batteries according to the correct polarity as indicated. To open the
battery compartment, press and slide down the cover until it clicks and locks. Further
sliding movement will remove the cover.
Handheld Transmitter
SQ-816(UHF) /
SQ-216(VHF)
1. Capsule with metal grille
2. Battery normal indicator (Green)
3. Battery low indicator (Red)
4. Power on/off switch
5. Channel switch
6. Charging port
Parts & functions
VHF Handheld Transmitter
Q-1002
Color cap
Battery status
LED indicator
Metal Grille
( Capsule module inside )
Parts and Functions
Power Switch
Battery compartment
cover
r
P ess
Battery Installation
Q-1002 uses 1 piece of 9V battery. To install new or replace the old battery, First
unscrew the battery cap from the battery compartment, then insert the new battery
according to its correct polarity as indicated. For longer operation hour, Alkaline
battery is recommended!
slide to "ON" position
After putting the battery cover back to the housing , slide the switch to "ON" position as
shown below.
As soon as the power is on, the battery-status indicator will give flash, indicating a
normal operation. If there is no flash, it indicates either power supply is not available
or battery is installed wrongly.
After switching on, the Therefore signal indicator LED(s) of matching receiver will light
up, indicating the microphone signal transmission is in normal operation.
Switch off the power when the microphone is not in use, meanwhile, remove the
battery out of microphone if it is not to be used for an extended period.
