1
K-2000A / K-2000AT Display User Manuals
Brief instruction
F1 Storage Mode (Set Transmitters number)
E1-Register Transmitters
E2-Register Remote Control
E3-Reigister Alarm Function Transmitters
E4-Register Cancel Function Transmitters
F2 Deletion Mode (Delete Transmitter Number)
E1-Delete Transmitters
E2-Delete Remote Control
E3-Delete Alarm Function Transmitters
E4-Delete Cancel Function Transmitters
F3 Display Setting
E1 Display Mode
E2 Storage Number
F4 Logout Setting (Remove Timing Setting)
F5 Cycle Mode
F6 Voice Setting
E1-Voice Mode
E2-
The times of Voice Announcements
E3-Whether to read the number when cycling
E4-Volume Setting
E5-Brightness setting
E6-Operational sound navigation
E7-
“
Number
”
position
E8-To be developed
E9-Whether read Counter Number (Suit for queue call system)
F7 Keyboard Setting
E1 Partition Setting
F8 Key Settings
E1 Single-key or Multi-key Setting
E2 Voice pairing
F9 Restore Factory Settings
: Setting key, Confirm key, Move digit key
: Exit system
: Up key, Increase number key
: Down key, Decrease number key
F1 Storage Mode
E1 Register Transmitters
1. Press “
” key 2 seconds, screen displays F1
2. Press “
” key, screen displays E1
3. Press “
” to confirm, screen displays 0001, “1” is flashing, and press “
” “
” “
”
key to select the number you want save.
4. Press any key from transmitter, you will hear a voice (success), the number has been
registered successfully and then the number will skip to the next one,.
5. Press “
” it will exit to “E1”, press “
” again to exit setting state.
NOTE: If you hear a voice (failure), it means the number has been used.
Note: Press the number on the screen directly, number will cancel
E2 Register Remote Control
1. Press “
” key 2 seconds, screen displays F1
2. Press “
” key, screen displays E1, press
to E2
3. Press “
” to confirm, screen displays 0001, “1” is flashing and press “
” “
” “
”
key to select the number you want to save.
