Chevrolet VOLT Owner Manual (GMNA-Localizing-U.S/Canada/Mexico-
9159388) - 2016 - crc - 10/21/15
Keys, Doors, and Windows
33
When all additional transmitters
are programmed, press and
hold POWER
O
for 12 seconds
to exit programming mode.
7. Return the key back into the
transmitter.
Programming without a
Recognized Transmitter
Program a new key to the vehicle
when a recognized key is not
available. Follow this procedure to
program up to eight transmitters.
Canadian regulations require that
owners see their dealer. This
procedure will take approximately
30 minutes to complete. The vehicle
must be off and all transmitters to
be programmed must be with you.
1. Remove the key lock cylinder
cap on the driver door handle.
See
Door Locks
0
37
. Insert
the vehicle key of the
transmitter into the key lock
cylinder on the outside of the
driver door and turn the key to
the unlock position five times
within 10 seconds.
The Driver Information Center
(DIC) displays REMOTE
LEARN PENDING,
PLEASE WAIT.
2. Wait for 10 minutes until the
DIC displays PRESS START
BUTTON TO LEARN and then
press POWER
O
on the center
stack.
The DIC display will again
show REMOTE LEARN
PENDING, PLEASE WAIT.
3. Repeat Step 2 two more times.
After the third time, all
previously known transmitters
will no longer work with the
vehicle. Remaining transmitters
can be programmed during the
next steps.
The DIC display should now
show READY FOR
REMOTE #1.
4. Remove the rubber mat in the
center console storage area.
5. Place the new transmitter into
the transmitter pocket.
6. Press and hold POWER
O
for
two seconds. When the
transmitter is programmed, the
DIC will show that it is ready to
program the next transmitter.
7. Remove the transmitter from
the transmitter pocket and
press
K
on the transmitter.
To program additional
transmitters, repeat Steps 5
–
7.
