Black plate (3,1)
Chevrolet Impala Owner Manual - 2013 - crc - 8/27/12
Keys, Doors, and Windows
2-3
With Remote Start Shown, Without
Remote Start Similar
/
(Remote Vehicle Start):
For
vehicles with this feature, press to
start the engine from outside the
vehicle using the RKE transmitter.
See
Remote Vehicle Start on
page 2
‑
4
for additional information.
Q
(Lock):
Press to lock all the
doors. If enabled through the Driver
Information Center (DIC), the
parking lamps flash once to indicate
locking has occurred. If enabled
through the DIC, the horn chirps
when
Q
is pressed again within
five seconds. See
Vehicle
Personalization on page 5
‑
33
for
additional information.
Pressing
Q
may arm the content
theft-deterrent system. See
Vehicle
Alarm System on page 2
‑
10
.
K
(Unlock):
Press once to unlock
the driver door. If
K
is pressed
again within five seconds, all
remaining doors unlock. The interior
lamps come on and stay on for
20 seconds or until the ignition is
turned on. If enabled through the
DIC, the parking lamps flash twice
to indicate unlocking has occurred.
See
Vehicle Personalization on
page 5
‑
33
.
Pressing
K
on the RKE transmitter
disarms the content theft-deterrent
system. See
Vehicle Alarm System
on page 2
‑
10
.
V
(Remote Trunk Release):
Press and hold for about
one second to open the trunk. The
transmission must be in P (Park).
L
(Vehicle Locator/Panic
Alarm):
Press and release to
locate the vehicle. The turn signal
lamps flash and the horn sounds
three times. Press and hold
L
for
more than two seconds to activate
the panic alarm. The turn signal
lamps flash and the horn sounds
repeatedly for 30 seconds. The
alarm turns off when the ignition is
turned to ON/RUN or
L
is pressed
again. The ignition must be in
LOCK/OFF for the panic alarm
to work.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to the vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
When the replacement transmitter is
programmed to the vehicle, all
remaining transmitters must also be
programmed. Any lost or stolen
transmitters no longer work once the
new transmitter is programmed.