10
16
Fold the cushion tabs into the slots and press
them in against the drive slot edge with a
straight edged tool or ruler.
15
Place the rotary seal face on a dry clean
cloth face side down to avoid scratching or
damaging the face. Peel the adhesive backing
from the rotary cushions. Align scored edges
with edges of slots and press to ensure
adhesion to that surface.
9.0
SEAL MAINTENANCE AND REPAIR cont.
Remove rotary seal ring from sleeve and
discard.
11
18
Apply a thin film of grease to the shaft O-Ring
and install in the sleeve inside diameter groove.
Apply a thin film of grease to the rotary O-Ring
and install in the rotary seal face outside
diameter groove
17
12
Remove shaft O-Ring from sleeve inside
diameter and discard.
13
Clean all metal components with approved
solvent.
Remove spare parts kit components from
packaging and place on a clean work surface.
NOTE:
Leave the two largest O-Rings
packaged for size identification.
14
10
Remove O-Ring from gland inside diameter
and discard.
20
Apply a thin film of the grease supplied to the
gland O-Ring and install in the gland inside
diameter groove.
19
Slide rotary seal face onto sleeve. Align drive slots with drive lugs in sleeve and press evenly on the
face to ensure proper spacing and that the seal face is seated. Wipe the seal face surface with a
clean soft cloth.
Not fully seated
Fully seated
