5
Use of Touch Controll Switch
A
ON/OFF
B
Speed Decrease Button
C
Screen
D
Speed Increase Button
E
Time Setup
F
Illumination Button
IMPORTANT NOTE
:
Be careful when the device is operated together with the devices using the air in the ambiant as a fuel at the same time (e.g. heaters
operating with gas, diesel fuels, coal or wood, water heater and etc.). Since the Cooker Hood throws the ambient air out, it might
have a negative effect on combustion.
Act in compliance with the rules and regulations related to the evacuation of exit air published by the authorized bodies. This
warning is not applied for the use without chimney.
MAINTENANCE
Turn the device off before starting any maintenance work. (plug off the power supply cable).
Aluminum Cassette Filter:
Aluminum Cassette Filter takes the dust and oil in the air. Metal filter should be washed with hot
soapy water every month or if it is possible in the dishwasher (60 C).
Removing the Aluminum Cassette Filter
-
Remove the Aluminum Cased Filter by pressing on the spring latches at the edge.
-
Do not install it before drying (Figure 7)
Carbon Filter
-
Carbon filter removes the smell in the air.
-
In normal use it has to be replaced with the new one every three months.
-
Never wash the carbon filter. In order to remove the carbon filter from its place turn it counter-clockwise.
Warning:
If you do not act in compliance with the cleaning and replacement rules related to the filters, it might result with fire.
Therefore we recommend you strictly obey the following instructions.
Cleaning:
The outer surfaces of your Cooker Hood should be wiped with a cloth rinsed in liquid detergent or alcohol. Never use
corrosive products.
Inox Cleaner:
This is a special protecting Inox product which cleans the fingerprints and spots on the products and avoiding the
rusting and other negative ambiance effects for a long time.
Disposal method:
Inox cleaner is dropped on a dry cloth and than Inox is wiped on the surface and the whole surface is wiped
with this liquid. After waiting a couple of minutes the cleaning and maintenance work are completed by rubbing the surface with
the same cloth. In this way a protective film layer is formed on the surface. This application should be made periodically without
waiting for any spotting.
