6. With poultry shears, you need to sharpe only the smooth convex blade. The concave (usually
serrated) blade will not need sharpening.
7. Do not attempt to sharpen serrated blades. However, where only one blade is serrated, the
other can be sharpened using the procedure for standard scissors. Look carefully for serra-
tions. They can be very small and difficult to see.
8. Scissors Adjustment: All “professional” scissors and many other scissors have a screw ten-
sioner at the pivot. The performance of your scissors and your scissors life may be improved
by adjusting this pivot to establish and maintain a smooth edge contact when you close the
scissors. Proper adjustment is determined by opening scissors to 50% of blade length, then
tightening
until
blade looseness is just barely removed. It is important that the pivot not be
overtightened. (If you are uncomfortable with this adjustment—seek assistance.)
normal maIntenanCe of the Scissorpro
®
No
lubrication is required for any moving parts, motor bearing surfaces or sharpening surfaces.
Your sharpener may be cleaned by carefully wiping with a damp cloth. Do not use detergents
or abrasives.
To clean metal dust that may accumulate in the sharpening section, simply remove the circular
plastic plug that is located on the underneath side of the sharpener. Shake out the metal dust and
replace plug. Do this once every eighteen months for normal use or more often with heavy use.
ServICe
In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory where
the cost of repair can be estimated before the repair is undertaken.
Please include your return address, daytime telephone number and a brief description of the prob-
lem or damage to the sharpener on a separate sheet inside the box. Retain a shipping receipt as
protection against loss in shipment.
8
Assembled in the U.S.A.
www.chefschoice.com
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked on the product.
Chef’sChoice
®
, EdgeCraft
®
, Diamond Hone
®
, ScissorPro
®
and the overall design of this product are registered
trademarks of EdgeCraft Corporation, Avondale, PA.
Conforms to UL Std. 982 Certified to CAN/CSA Std. C22.2 No. 1335.1
Certified to EN 60335-1, EN 60335-2, EN 55014-1+A1, EN 61000-3-2, EN 61000-3-3
© EdgeCraft Corporation 2012
Printed in China.
A12 2012-01
C158200
EdgeCraft Corporation
825 Southwood Road, Avondale, PA 19311 U.S.A.
Customer Service (800) 342-3255 or 610-268-0500
Send your sharpener (insured and postage prepaid) to:
