3
Operation
Raise the mixing head by pressing button 5, this will release the head
and allow it to be raised
Place the mixing bowl into the housing and twist until it locks in place
Put the desired accessory into the drive shaft and twisting to lock into
place
Push the mixing head down until it locks into place
Plug into the mains and select the required mixing speed on the dial, as
soon as the dial is turned the mixer will start
Cleaning & Maintenance
Before cleaning disconnect the Mixer from the electricity supply
A wet cloth can be used to clean the mixer housing
DO NOT submerge the Mixer in water or use water sprays to clean it
The bowl & accessories can be cleaned in hot water or a dish washer
Dry the product thoroughly and keep it in a dry place
Always clean your Chefmaster Mixer daily
Troubleshooting
Fault
Possible Cause
Solution
The unit is plugged in but
indication light is not on /
not working
The plug or lead are
damaged
The fuse has blown
Contact your Chefmaster
distributor
Replace the fuse
The indication light flickers
and the unit is not working
The back cover is not
installed properly
The dial is not pointed to
“0” when the unit is
plugged in
Reinstall the back cover
Reset the dial to
“0”
The mixing bowl wobbles
The mixing bowl is not
locked into place
Twist the mixing bowl until it
is locked into place
The unit stops running
during operation
The plug / lead / fuse are
damaged
Overload Heat
protection is triggered
Contact your Chefmaster
distributor / Replace the fuse
Remove the plug from
mains. Plug in again after
20 minutes.
