NON-DUCTED MODE
5
6
2
.
Please
open
the
carton
box
and
make
sure
the
foam
under the
wind
wheel
is
take
off
before
install
Foam board
4.
Mark the wall by following the moun ng
hole to center the range hood. Drill the 2
moun ng screws (AA) into the wall.
4.
Mark the wall by following the moun ng
hole to center the range hood. Drill the 2
moun ng screws (AA) into the wall.
6.
A ach and secure vent pipe to the adapter. Use
aluminum tape and wrap around the connec on
to make it air ght. Please note,to reduce the risk
of fire use metal ductwork.(Metal duct should be
purchased separately)
1
.
Carefully
mark
the
range
hood
placement
on
the
wall
.
Range
hood
should
be
placed
at
a
distance
of
24
''
to
30
''
or
recommended
by
local
building
code
.
21mm
Holes on wall
5.
Mount the range hood to the two moun ng
screws that were installed in Step 4.
3.
A ached the 6in. round adapter to the
outletand secure it using four screws
(BB) with gaskets (CC).
7.
A ach the bracket to the inner duct cover and
secure by 2 screws (EE) onthe side. Carefully
insert both duct cover into the range hood.
8.
Adjust to the desirable height by raising the
innerduct cover and secure the posi on with
the bracket installed in Step 7 using the two
screws (DD) provided.
Recircula on Mode
Cau on:Do not use plas c or rigid metal duc ng.
1. Install the charcoal filter on.
2. Please note that the air will flow out from the
two grids on
the two sides of the chimney top.
