Check Point SMB 1500 Series, Reference Manual

Page: 279 / 1401

cphaprob
SMB 1500 Appliance Series R80.20.05 CLI Reference Guide | 279
Parameter Description
list
Displays that state of:
-i - Internal (as well as external) devices, such as interface check and High Availability
initialization.
-e - External devices, such as devices registered by the user or outside the kernel. For
example, fwd, sync, filter.
-ia - All devices, including those used for internal purposes, such as note initialization
and load-balance configuration.
state
Displays the state of all the gateways in the High Availability configuration.
if
Displays the state of interfaces.
Example
cphaprob -d $process -t 0 -s ok -p register
Output
Success prints OK. Failure shows an appropriate error message.
These are some typical scenarios for the cphaprob command.
Argument Description
cphaprob -d <device> -t
<timeout(sec)> -s
<ok|init|problem> [-p]
register
Register
<device>
as a critical process, and add it to the
list of devices that must be running for the cluster
member to be considered active.
cphaprob -f <file> register
Register all the user defined critical devices listed in
<file>.
cphaprob -d <device> [-p]
unregister
Unregister a user defined
<device>
as a critical process.
This means that this device is no longer considered
critical.
cphaprob -a unregister Unregister all the user defined
<device>
.
cphaprob -d <device> -s
<ok|init|problem> report
Report the status of a user defined critical device to
ClusterXL.
cphaprob [-i[a]] [-e] list
View the list of critical devices on a cluster member, and
of all the other machines in the cluster.
cphaprob state View the status of a cluster member, and of all the other
members of the cluster.
cphaprob [-a] if
View the state of the cluster member interfaces and the
virtual cluster interfaces.