16
Attaching the Upgrade Sticker
After you install new DIMMs, attach the upgrade sticker on the Security
Management Appliance.
To attach the upgrade sticker:
1.
Make sure that the Security Management Appliance operates correctly.
2.
Attach the upgrade sticker on the Security Management Appliance cover.
Make sure that the upgrade sticker does not block the ventilation holes.
Verifying the Memory Configuration
To make sure that the memory configuration is correct:
1.
In the CLI, enter Expert mode.
2.
Run:
# free –g –o
Example for Smart-1 225 with 16GB of memory:
[Expert@gw-419463:0]# free -g -o
total used free shared buffers cached
Mem: 15 0 15 0 0 0
Swap: 16 0 16
Note
- The amount of installed memory is shown in the row named
Mem
under the column named
total
.
For reasons related to available memory address space, the total
installed memory shown in the
free
utility is similar but not identical
to the actual installed memory.
In the above example, 16GB of RAM are installed on the system. This
corresponds to the 15GB of total memory shown in the
free
utility.
