Check Point 61000 Security System Getting Started Guide R75.40VS for 61000 | 59
CHAPTE R 10
Step 8: Initial Software Configuration
In This Section:
...................................................................................................
..............................................................................................
When you install and configure the 61000 Security System, start with the Security Gateway Module
furthest to the left in the Chassis. After the first SGM is configured, installation and configuration
settings are automatically propagated to all other SGMs in the defined
security group
. The
Security Group is the group of SGMs that make up the Security Gateway.
Note
- In SmartDashboard, one Security Gateway object represents all the SGMs in the security
group.
Connecting a Console
1.
Connect the RJ-45 jack end of a serial cable to the console port on the left-most 61000
Security System in the Chassis.
2.
Connect the other end of the serial cable to the computer that you will use to do the initial
configuration of the 61000 Security System.
3.
On the configuration computer, connect to the 61000 Security System using a terminal
emulation application such as PuTTY.
•
Make sure the Speed (baud rate) is set to 9600
•
No IP address is necessary
4.
Log in with username:
admin
and password:
admin
.
