Page 10
Installation Instructions
10.
Remove the adhesive release paper.
This paper must be removed, as IT
WILL BURN.
11.
Attach the heating elements
to the foam bun (not the seat cover) by pushing
down on the pads causing the adhesive to stick completely to the foam bun.
NOTE:
Element may be hard to handle if you tear the release paper off all at once. Paper can be
peeled away in increments as you apply the element to the foam bun. Apply cushion
element rear to front and back element bottom to top.
RELEASE PAPER MUST BE
COMPLETELY REMOVED. FAILING TO COMPLETELY REMOVE PAPER IS A FIRE
HAZARD AND NULLIFIES AND VOIDS WARRANTY.
12.
Re-install seat trim covers.
Do not install hog rings through the heating
element.
THE SEAT LISTING WIRES SHOULD NOT LIE DIRECTLY ON TOP OF THE
HEATING ELEMENTS. IF THE LISTING WIRES MUST CROSS THE PADS IN THE
CHANNELS, ADD SOME FOAM FOR PROTECTION.
13.
Install the seat into the vehicle
14.
Reconnect airbag connectors
15.
Reconnect the ground of the battery
16.
Connect the extension harnesses
to the controller as shown in the wiring
diagram.
17.
Mate all remaining connectors
(as shown in the wiring diagram).
SECURE
THE WIRE WITH THE TIES PROVIDED. CHECK THAT THE RECLINING OF THE
SEATS, OR THE MOVEMENT OF THE SEAT FRAME DOES NOT PULL, FRAY, OR
CUT THE WIRES
18.
TEST SEAT FUNCTIONS
; RECLINE, FORWARD, REVERSE, UP, DOWN,
ETC. ENSURING THAT NO STRAIN IS PLACED ON ANY OF THE SYSTEM’S WIRES.
Ensure all of the anchor bolts are tight to the manufacturer’s specification.
Using the Seat Heater for the First Time (before you deliver to your customer)
OPERATION OF THE HEATED SEATS:
After turning the system on high setting,
you must sit in the seat
and should be able to feel
heat within 1-5 minutes depending on the thickness of the trim cover material over the
element.
The thicker the trim cover, the longer it takes to feel the heat.
