JP4-KBD
MIDI Interface forJupiter-4 Keyboard
Model 8-432 ver. 2.0
Copyright © 2012 CHD Elektroservis
All rights reserved. No part of this publication may be reproduced in any form without written permission of CHD Elektroservis.
10
3.2. COMMON SYSTEM COMMANDS
3.2.1. CLOCK
If “Arpg Clock Rate“ parameter is equal to 0, “MIDI Clock” commands are ignored. For values
of “Arpg Clock Rate“ higher than 0, interface receives synchronization impulses of “MIDI Clock” and
arpeggiator tempo is derived from them (see chapter 2.5.).
Maximum tempo of arpeggiator is limited by the instrument’s hardware. When extremely high
speeds of MIDI Clock and song tempo are used, the arpeggiator can play out of the tempo or omit
several notes.
3.2.2. RESET
Complete interface reset is done after receiving “Reset“ command – all parameters are set to
their default values stored in internal memory. This is the same status as if the instrument is switched
on.
3.3. SYSTEM EXCLUSIVE MESSAGES
The MIDI System Exclusive communication enables to adjust the values of all interface
parameters. System Exclusive communication is described in detail in standalone manual.
For easier SysEx Message creation please use the software generator available on the
attached CD-ROM or at "http://www.chd-el.cz" website.
Cakewalk™ or Sonar™ users can use pre-defined Studio Ware Panel for easier operation,
available on the enclosed CD-ROM or at "http://www.chd-el.cz" website.
APPENDICES
A. WARRANTY CONDITIONS
Equipment comes with
thirty-month warranty
starting from the date of equipment take-over by
the customer. This date must be specified on warranty list together with dealer's confirmation.
During this period of time, all defects of equipment or its accessories, caused by defective
material or faulty manufacturing, will be removed free of charge.
Warranty repair is asserted by the customer against the dealer.
Warranty period is to be extended for the time period, during which the product was under the
warranty repair.
Relevant legal regulations take effect in case of cancellation of purchase contract.
Customer will lose the right for free warranty repair, if he will not be able to submit properly filled
out warranty list or if the defects of the product had been caused by:
- unavoidable event (natural disaster),
- connecting the device to incorrect supply voltage,
- inputs or outputs overloading by connecting the signals source or load source with not-corresponding
characteristics etc.,
- faulty equipment operation, which is in conflict with instructions referred-to in the operating manual,
- mechanical damage caused by customer during transportation or usage of equipment,
- unprofessional interference with the equipment or by equipment modification without manufacturer’s
approval.
Summary of Contents for 8-432
Page 1: ...7 Model 8 432 ver 2 0 USER S GUIDE 2012 CHD Elektroservis...
Page 12: ...7...
