24
The measured value is displayed on the screen.
3.9
CURRENT MEASUREMENT (A)
The jaws are opened by pressing the trigger on the body of the device. The arrow
on the jaws of the clamp (see the diagram below) must point in the presumed
direction of flow of the current, from the generator to the load. Make sure that the
jaws have closed correctly.
Remark:
the measurement results are optimal when the conductor is centred in the
jaws (aligned with the centring marks).
3.9.1
AC measurement
For an AC current measurement, proceed as follows:
1.
Set the switch to
.
2.
Encircle only the conductor concerned with the clamp ;
The measured value is displayed on the screen.
Summary of Contents for F401
Page 1: ...F401 Clamp multimeter GB User s manual...
Page 38: ...692885A02 Ed 7 08 2016...
