Setup
-10-
WELL™ Quad-M User Manual
W-DMX™ Operation
The product can operate in W-DMX™ mode up to 300 m (900 ft) from the
W-DMX™ transmitter. For wireless operation, the W-DMX™ receiver inside the product
must be paired with a W-DMX™ transmitter.
Initial Setup
1. Turn the W-DMX™ transmitter on.
2. Connect the W-DMX™ transmitter to a DMX controller.
3. Place the product within 300 m from the W-DMX™ transmitter.
4. Disconnect any DMX cable from the product.
5. Turn the product on.
Configuration
1. From the product’s control panel, go to
RUN > DMX
.
2. Select the desired DMX start address. .
3. Go to
WDMX > ACTI
.
4. Select
ON
.
Product Pairing
Product currently paired with the transmitter
•
If the product is paired with the W-DMX™ transmitter, a red LED on the On/Off
switch will slowly flash. The product is ready to work in wireless mode.
Pairing the product with a new W-DMX™ transmitter
1. From the product’s control panel, go to
WDMX > REST
.
2. Select
YES
(a red LED appears on the On/Off switch).
3. From the W-DMX™ transmitter, press <
RESET
> (the SIGNAL indicator will flash).
4. Once the transmitter has found the product, the SIGNAL indicator on the W-DMX™
transmitter will illuminate solid.
5. From the On/Off switch, the red LED flashes slowly indicating the presence of DMX
signal.
W-DMX™ operation can be interrupted or inhibited by liquid masses between the
transmitter and receiver such as water, snow, or people. For best results, keep
the antenna clear of any liquid mass.
WDMX™ Setup
Control Panel
WDMX Transmitter