Page 10 of 18
TriShot™ LED User Manual (Rev. 01a)
Static Colors
To enable the Static Colors mode, do the following:
1) Set DIP switch [8, 9, 10] to the
ON
position.
2) Use DIP switch [1~6] to set the color. See the chart below to see what color each
DIP switch controls.
Red
Green
Blue
[1, 2]
[3, 4]
[5, 6]
You may combine DIP switch for same color to increase the intensity.
Master/Slave Mode
This mode allows a single TriShot™ LED unit (the “master”) to control the actions of
one or more TriShot™ LED units (the “slaves”) without the need of a DMX controller.
The master unit will be set to operate in either Automatic or Sound Active mode, while
the slave units will be set to operate in Slave Mode. Once set and connected, the
slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1) Set DIP switch [2~10] to the
OFF
position.
2) Set DIP switch [1] to the
ON
position.
3) Connect the DMX input of the first slave unit to the DMX output of the master unit.
4) Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
5) Finish setting and connecting all the slave units.
Master unit:
1) Set the master unit to operate in either Automatic or Sound mode, as previously
indicated.
2) Make the master unit the first unit in the DMX daisy chain.
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because it may interfere with the signals from the master unit.
Do not connect more than 31 slave units to the master unit.
