Chauvet Stage Designer 50 TFX-48B, User Manual, Page: 11 / 24

Stage Designer™ 50 User Manual
11
Revised: 2008-08-25 16:16:53
E RAS E A P RO G R AM
Action

1) Record enable.
2) Use the Page button to select the page the
Scene you wish to erase is on.
3) Press and hold the Edit button & tap the
Flash button (13-24) twice of the Scene you
wish to erase.
4) Release the 2 buttons. The LED for the
corresponding program should light,
indicating that it has been selected.
5) Press the Delete button. All LEDs should
light, indicating the program is erased.
Notes

E RAS E AL L S CE NE S
Action

1) Record enable
6) Press and hold RECORD .
2) While holding Record button, tap the flash
buttons in the following sequence: 1-3-2-3.
Release the Record button.
7) All LEDs should light, indicating all
programs have been erased.
8) Press and hold RECORD & REC EXIT to
exit the mode.
Notes

You must be in Record mode to Reset the controller.
The LED over the Record button will light, indicating
the Record mode operation.
Warning : this will reset the controller to its factory defaults. This will erase all programs and settings.
RE CO RD CL E AR
Action

1) Record enable.
2) Record a scene with 1 or more steps.
3) If you are not satisfied with the scene, you
may press and hold the
Record button &
tap the Page/REC CLR button. All LEDs will
flash, indicating the scenes have been
cleared.
Notes

All scenes stored in the temporary memory of the
controller will be erased by this process.
This process will not affect the scenes already
programmed into a Scene fader.