Scorpion™ Storm RG User Manual
13
1/26/2009 3:33 PM
5.
O
PERATING
I
NSTRUCTIONS
Stand-Alone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode. When all dipswitches are in the Off position, the unit will run in sound active mode.
You may use a combination of the dipswitches to create your desired effect.
Note: the counter-clockwise rotation takes precedence over the clockwise rotation.
1)
Set dipswitches position, as desired, using the below values.
Dipswitches
Function
1
On: Auto Off: Sound Active
2
On: Red (can be used in auto, rotation)
3
On: Green (can be used in auto, rotation)
4
On: right rotation; slow
5
On: right rotation; medium
4+5
4+5 On: right rotation fast
6
On: rotation in both directions; slow
7
On: rotation in both directions; medium
6+7
6+7 On: rotation in both directions; fast
8
On: strobe; slow
9
On: strobe; medium
8+9
both 8+9 On: strobe; fast
10
On: DMX operation/mode
2)
The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode, or the unit will auto change in Auto Mode.
3)
Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. You must place the fixture
into DMX mode by turning the dipswitch #10 to the on position. If you are unfamiliar with DMX, please
read the DMX Primer on page 18.
-The example listed below demonstrates a fixture set to DMX mode at DMX address 001.
DMX Mode
Switch # 10
= On
Switch # 1
= On
