Chauvet Rogue R3 Wash, User Manual

Page: 17 / 52

Page 14 of 49
Rogue R3 Wash User Manual Rev. 1
O
PERATION
Pan Angle
This option assigns pan range.
1. Highlight Pan Angle , press <ENTER> .
2. Select 540 , 360 , or 180 , press <ENTER> .
Tilt Angle
This option assigns tilt range.
1. Highlight Tilt Angle , press <ENTER> .
2. Select 90 , 180 , or 230 , press <ENTER> .
X/Y Mode
This option assigns tilt range.
1. Highlight Fast or Slow press <ENTER> .
2. Select 90 , 180 , or 230 , press <ENTER> .
Fans
This option allows you to choose a fan mode. AUTO mode controls the fan speed based on the
temperature of the LED’s. In ECO mode, fans will stay as quiet as possible and allow the output of the
LEDs to decrease by about 20% over time depending on the ambient temperature. As the ambient
temperature increases, the output of the LEDs will decrease. In
Full mode, the fans are on all the time at
the highest speed.
1. Highlight Fans , press <ENTER> .
2. Select Auto , ECO , or Full , press <ENTER> .
Display
Determines whether or not the backlight of the display will stay on after last command button pressed.
1. Highlight Display , press <ENTER> .
2. Select OFF or ON , press <ENTER> .
Screen Reverse
To invert the control panel screen:
1. Highlight Screen Rev , press <ENTER> .
2. Select YES or NO , press <ENTER> .
Dimmer Curve
This option allows you to choose a dimmer curve mode. Linear mode follows the speed of the user
controlling the fader when it is brought down to a “0” value. In Square mode the dimmer follows a square
dimming curve when the fader is brought to a “0” value. In I Square mode the dimmer follows a square
dimming curve in reverse when the fader is brought to a “0” value. In SCurve mode, the dimmer follows a
square dimming curve when the fader is brought to a “0” value.
1. Highlight Dimming Curve , press <ENTER> .
2. Select Linear , Square , I Square , or SCurve , press <ENTER> .
Dimmer Speed
This option sets the speed of the Dimmer Curve menu option.
1. Highlight Dimmer Speed , press <ENTER> .
2. Select Smooth or Fast , press <ENTER> .
Color Calibration
This programming level allows the user to set what each of the RGBW DMX channels dowhen set to a
“255” value.
• Starting from the Setup screen level, select Color calibration, press <ENTER> .
Factory calibration
This option chooses to set the color temperature calibration to Off or On . When RGBW
DMX channels are at full, setting to Off sets the fader to Max. output on each of the
RGBW DMX Channels or to On which uses the factory calibrated color temperature.
• Highlight On or Off , press <ENTER> .