Rogue R1 FX-B QRG
EN
3
Power Linking
You can link up to 8 Rogue R1 FX-B products at 120 V, 14 products at 208 V, or
15 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
AC Plug
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow/Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Replacing The
Fuse
1.
Disconnect this product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and rating.
4.
Screw the fuse holder cap back in place and reconnect power.
Signal
Connections
You can link the Rogue R1 FX-B to a controller or controller software using a DMX
connection, an Ethernet connection, or both. If using other Art-Net™, sACN, or
Kling-Net -compatible products with the Rogue R1 FX-B, you can control each
individually on a single network. See the User Manual for information about how to
connect and configure the product for these signals.
Control
Personalities
The Rogue R1 FX-B uses DMX, Art-Net™, sACN, and Kling-Net for its control
personalities:
Single Control
Dual Control Movement
Dual Control Pixel
Tour 2
(52-channel)
Tour
(47-channel)
Advanced
(47-channel)
Advanced
(23-channel)
RGBW
(20-channel)
Standard
(25-channel)
Standard
(17-channel)
RGB
(15-channel)
Basic
(18-channel)
Basic
(10-channel)
Uses DMX, Art-Net,
sACN, or Kling-Net
Uses DMX, Art-Net™, or sACN
DMX Connection
The Rogue R1 FX-B will work with a DMX controller using a 3- or 5-pin DMX
data connection. A DMX Primer is available from
www.chauvetprofessional.com
.
Art-Net™
Connection
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount
of DMX512 data using an Neutrik® etherCON® RJ45 connection over a large
network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com.
Chauvet Professional recommends using unicast
Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the
layering and formatting of Architecture for Control Networks to transport DMX512
data over IP or any other ACN compatible network. ACN is maintained by the
Professional Lighting and Sound Association (PLASA).
Kling-Net
Connection
Kling-Net is a network protocol that allows auto configuration of display devices
using a Neutrik® etherCON® RJ45 Ethernet connection. Refer to the ArKaos
software manual for detailed instructions on programming this product.
For smooth-running operation, ArKaos Kling-Net requires a gigabit (1000
Mbps) Ethernet card and network router.
