Q-Mix User Manual
6
2006-10-11/13:16
Slide switch up or down
depending on your line voltage.
S1
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. An ELC halogen lamp is
included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L a m p I n s t a l l a t i o n
1. Remove screws labeled (S1) and pull cover
plate.
2. The lamp is encased in a mirror reflector. Slide
entire reflector out of the lamp cage and
disconnect from socket. If replacing the lamp,
remove old lamp first.
3. Replace with new lamp and slide back into the
lamp cage.
4. Replace the cover, align the screw holes and
fasten the screws back onto the cover.
Power
Your product is equipped with switch-selectable AC power setting.
Warning!
Verify that the power select switch on your unit
matches the line voltage applied. All fixtures must
be connected to circuits with a suitable Earth
Ground.
•
To determine the power requirements for a particular fixture,
see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart.
•
A fixture’s listed current rating is its average current draw under normal conditions.
•
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
•
Before applying power to a fixture, check that the source voltage matches the fixture’s
requirement.
•
All fixtures must be connected to circuits with a suitable Earth Ground.
P ow e r C a b l e C o n f i g u r a t i o n
C
ABLE
P
IN
I
NTERNATIONAL
B
ROWN
Live L
B
LUE
Neutral N
Y
ELLOW
/G
REEN
Earth EG
(Ground)