5A
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4”
microphone jack of the first unit, you will find that the remote control on the first unit will control
all the other units for Stand by, Strobe/Next and Fast/Slow function.
1. STAND BY
: To blackout all the unit.
2. STROBE/NEXT
: Under FAST/SLOW mode, the lights have six
different effects, press NEXT button to choose desired effect.
Effect 1: Light green on, barrel reflector in slow motion.
Effect 2: Light green & red on in turns, barrel reflector in
slow motion.
Effect 3: Light green & red on together, barrel reflector in
slow motion.
Effect 4: Light green on, barrel reflector in fast motion.
Effect 5: Light green & red on in turns, barrel reflector in fast motion.
Effect 6: Light green & red on at the same time, barrel reflector in fast motion.
3. FAST/SLOW
: When the LED is off, it is in FAST mode. The unit’s Pan/Barrel is sound
activated and Pan scans/moves fast. If the LED on, it is in SLOW mode, Pan/Barrel is sound
activated but Pan scans/moves slowly.
4.3 Universal DMX Controller
If you use a universal DMX controller to control the units, you have to set DMX address from 1
to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press and keep
ENTER
button pressed up to when the
display stops blinking or storing automatically 8 seconds later. To go back to the functions
without any change press the
MENU
button again.
Please refer to the following diagram
to address your DMX512 channel for the first 4 units.
4. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting
will be effected at once. Every time you turn the unit on, it will show A-rL on the display and
move all the motors to their ‘home’ position and you may hear some noises for about 20
seconds. After that the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give
an automatic, sound activated, synchronized light show. This function is good when you want
an instant show. Its DMX input jack will have nothing plugged into it, and Its master LED will be
constantly on and sound LED will flash to the music. The other units will have to set in slave
mode
and select
(normal) or
(2 light show) mode, Their DMX
cables plugged into the DMX input jacks (daisy chain) and the slave led lights will constantly
on.
2-light show
In
(slave mode),
means the unit works normally and
means 2-light
show. In order to create a great light show, you can set
on the second unit to get
contrast movement to each other, even if you have two units only.
