Introduction
LED-RAIN56 User Manual
6
2009-12-08/16:28
Hanging Clamp
(sold separately)
S
ETUP
Power
This fixture has an auto-switching power supply that can accommodate a wide range of input voltages. The
only thing necessary to do before powering on the unit is to make sure the line voltage you are applying is
within the range of accepted voltages. This fixture will accommodate between 100 V and 240 VAC. To
determine the power requirements for a particular fixture, see the label affixed to the back plate of the
fixture or refer to the fixture’s specifications chart.
A fixture’s listed current rating is its average current draw under normal conditions.
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
All fixtures must be connected to circuits with a suitable Earth Ground.
Po w e r C a b l e C o n f i g u ra t i o n
C
ABLE
P
IN
I
NTERNATIONAL
B
ROWN
Live
L
B
LUE
Neutral
N
Y
ELLOW
/G
REEN
Earth
G (Ground)
Mounting
O ri e n t a t i o n
This fixture may be mounted in any position provided there is
adequate room for ventilation.
R i g g i n g
The fixture includes a mounting yoke to which 1 rigging clamp can be bolted.
1. Align the clamp screw with the center hole on the yoke and tighten.
2. Verify the structure can hold 10 times the weight of all to-be installed fixtures.
3. Adjust the angle on the yoke arm as necessary.