4. Operating Instructions
9
9/13/2010 2:33 PM
DMX Operation
This operating mode allows control of the fixture with an external DMX controller. You must set the
starting address for this mode. If this is your first time using DMX, then it is recommended that you
refer to the “DMX Primer” section in the “Appendix” of this manual.
1. Press
<MENU>
until
512
appears on the LED screen.
2. Press
<ENTER>
.
3. Using
<UP>
and
<DOWN>
, select the desired DMX address (
d001
~
d512
).
4. Press
<ENTER>
.
All fixtures must be individually set to DMX using the instructions above.
Master/Slave Mode (Sound-Active, Auto Mode)
This mode allows a single unit to run to the beat of the music, or the unit will change automatically.
DMX cables must be used to daisy chain between the fixtures from the output of the master unit.
Master:
1.
Set the master unit to run in either
Automatic mode
or
Sound-Active mode
. Please
see the appropriate sections on this user manual for instructions on this process.
Slave:
1. Press
<MENU>
until
512
appears on the LED screen.
2. Press
<ENTER>.
3. Using
<UP>
and
<DOWN>
, set the starting address to
d001
.
4. Press
<ENTER>.
All fixtures must be individually set to either master or slave mode using the instructions
above.
Only one fixture may be set to master. Having two or more fixtures in the same daisy chain
will prevent the fixtures from working properly.
Do not connect a DMX controller for this setup.
